9204 search results for test

E8V59

, TEMPORARY-CRITICAL, STEEL H-PILES WITH TIMBER LAGGING SF 1,411.000 0455-137- LOAD TEST (DYNAMIC), DATA COLLECTION AND ANALYSIS EA 148.000 0455-137- 2 LOAD TEST (DYNAMIC), VERIFICATION TEST EA 9.000 0455-143- 5 TEST PILES-PRESTRESSED CONCRETE,24" SQ LF 400.000 0455-144- 22 TEST PILES - STEEL

DCTA meeting minutes May 2 2000

passed the ACI concrete Testing (not to be confused with the DOT Concrete Testing Level I

7830000RESPON

and would avoid additional testing. ITS SECTION RESPONSE: Comment was accepted and incorporated, wavelength(s) for OTDR testing (either 1310, 1550, or both 1310 and 1550). ITS SECTION RESPONSE

LAP_Cert_2015

) Materials Testing Requirements (Question 11d) • The District LAP Te a m will coordinate with the District, Assurance Review of the local agencies materials testing procedures for off-system projects

4551501.resp

) 414-4305 Larry.Jones@dot.state.fl.us Comments: (10-14-10) Based on testing performed during the FDOT, of shaft to a point high enough above top of shaft to allow cross-hole-sonic-logging testing…. 4

4300202.resp

the accuracy and repeatability of laser video inspection testing. Specifically, the need was discussed, -installation pipe inspections on FDOT projects. The proposed specification removes mandrel testing

7850300.origind

responsibility for performance of all quality control testing and inspections in accordance with Sections 346, the requirements of 105-3. Assume responsibility for performance of all quality control testing

SP0073100 FHWAadmin

testing entities (42 U.S.C. §§ 12131 – 12189) as implemented by Department of Transportation regulations, transportation systems, places of public accommodation, and certain testing entities (42 U.S.C

5150100-724FHWA

visually inspect all welds for final approval. Nondestructive testing of welds is not required, . Nondestructive testing of welds is not required, unless otherwise shown in the Plans. Prior to installation

0073100.FHWA2

, and certain testing entities (42 U.S.C. §§ 12131 – 12189) as implemented by Department, testing entities (42 U.S.C. §§ 12131 – 12189) as implemented by Department of Transportation

5150000.FHWA

: Nondestructive testing of welds is not required, unless otherwise shown in the Plans. 515-3.2.1 Aluminum, : Nondestructive testing of welds is not required, unless otherwise shown in the Plans. 515-3.2.1

0073000.FHWA2

of public accommodation, and certain testing entities (42 U.S.C. §§ 12131 – 12189) as implemented, , and certain testing entities (42 U.S.C. §§ 12131 – 12189) as implemented by Department

1090000.FHWA

to store surveying instruments and testing equipment. Provide the room with lock and electrical outlet, and testing equipment. Provide the room with lock and electrical outlet. (n) Fire Extinguisher

ITB-DOT-1516-9039-CA

to additional testing of individual lots, batches or shipments to construction projects or against

9970000-122FHWA

submitted must be tested and approved. Provide products constructed of corrosion-resistant materials, with the Department’s polling and processing software. Any substitute software modules submitted must be tested

2024-2025 2nd Quarter SRES Report

E6P87ScopeOfServices

DB - Prescoping questions CLEAN 4-25-2025

or of unknown type, perform all required testing of reinforced backfill, and include the results, ) S.54Specify any additional functional checkout tests that will be required for the project. (SDG 8.1.11

Appendix A

certified welders should weld structural steel members. • Conduct any necessary non-destructive testing, , and/or using compressed air. • Steel shot blast and sandblast. • Apply test patches to verify, . • Test patches to verify ability of operator. • Remove deteriorated concrete using pneumatic hammers

BMRM Appendix A

certified welders should weld structural steel members. • Conduct any necessary non-destructive testing, , and/or using compressed air. • Steel shot blast and sandblast. • Apply test patches to verify, . • Test patches to verify ability of operator. • Remove deteriorated concrete using pneumatic hammers